3/31/2024 0 Comments Serial port cncYou have to terminate any other processes that are using the serial port (such as putty) before you try opening Candle. On Monday, April 27, 2020, 09:39:16 AM EDT, keith sager wrote: On Monday, April 27, 2020, 09:41:09 AM EDT, keith sager wrote: don't know why this is such a pain in the ass I have been getting this far, they sent me new firmware and to use this x loader but this is as far as it will go. Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread. The ones labeled RxD and TxD should blink during the serial communication. The LEDs labeled 24V, 12V, and 5V should all be lit. If it is the Woodpecker control board, it should have a few LEDs on it. Post a foto of the PCB that is on the back of the machine. If the machine does not respond, it's most likely a problem with the hardware or missing firmware. Refer to for the serial port config and basic commands. Try connecting with a terminal program such as PuTTY. Your CNC may be missing the Grbl firmware. I tried multiple versions of candle for this with same result? when unplugged from laptop I have T R P lights on and when I plug in only P light is on. I have no blinking lights and it says serial port error 1 no file or directory it wont take $ command.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |